2.54mm Straight Pin Female Connectors

2.54mm Straight Pin Female Connectors

The technical requirements for the connection of the bus bar are

Bus bar lap connection requirements: bus bar and bus bar, bus bar and electrical terminal connection, should comply with the following provisions: the same arrangement of the main bus bar, branch bus bar, lead wire and equipment connection bus bar should be consistent, horizontal and vertical, neat and beautiful.Board to board connector
Collar bus bar lap connection: should comply with the provisions of Table 6.New energy connection line
Bus bar lap surface requirements: bus bar lap surface should be flat, fastening value should meet the requirements, bus bar should be free of cracks, deformation and looseness.Board to wire connector
Bus bar connection should be done after the voltage test, the test voltage is 1.5 times the working voltage, lasting 1 minute, no breakdown phenomenon.
Bus bar installation requirements: bus bar should be assembled according to the design requirements, assembly before each segment should be measured insulation resistance, the measurement results should meet the design requirements. Bus bar installation height should meet the design requirements, installation arrangement should be hierarchical. The contact surface between bus bar and bus bar, bus bar and electrical terminals should be naturally fit. Busbar connection surface contact should be close, and its fastening value should meet the requirements. Busbar support parts should have sufficient mechanical strength to withstand the mechanical stress generated by the line short-circuit current. If the distance between the two support points of the bus bar is too large, the support point should be increased in the middle.
Busbar row bend is not allowed to appear cracks.
After the busbar is installed, it should be neat and beautiful to facilitate the maintenance and overhaul of electrical appliances and busbars, while checking the distance between phases and to ground, which should meet the requirements.

[Product name] : Row needle row female Jane Ox horn
[Pitch] :1.0/1.27/2.0/2.54
[Material] :PBT PA6T PA9T PPS
[Style] : Single row/Double row/Three row/four row/In-line /90 degree /SMT
[Color]: Black and white
[Explanation] : Free sample, according to customer requirements arbitrary customization

Connectors are an indispensable part of electronic equipment. Our main products are: Round connector, Square pin row female connector, board to board connector, board to board connector, board to wire connector, New energy connector, round hole pin row connector, female connector, Cabinet Light connector, four policy pin row connector, female connector, Jane Ox connector, Ox horn connector, wire to board connector, top connector, flat cable, DuPont flat cable, wiring harness, IDC socket